We're Excited to welcome you at our Newly renovated Connaught Place Store, so if you’re nearby, stop by.

Enabling standby (low power) mode

You can enable standby (low power) mode by removing the Ethernet cable and disabling Wi-Fi and Bluetooth®. This will prevent the system from connecting to your network and any Bluetooth device, as well as preventing the amp from being controlled by the SoundTouch® app until Wi-Fi and Bluetooth are re-enabled.

On the back of the SoundTouch® pedestal, press and hold the Control button for about 8–10 seconds until the Wi-Fi indicator turns off

Within a few minutes, the unit will enter standby mode

To re-enable wireless network capabilities, including Bluetooth, press the Control button or press the Power button on the remote

Was this helpful?


Thank you for submitting your comments.