Setting up system

To set up the system, follow these steps:

Insert one end of the audio input cable into the Acoustimass® module jack on the control console

Insert the other end of the audio input cable into the Media Centre jack on the Acoustimass® module

Insert the RCA plug of each speaker cable into the five speakers jacks on the Acoustimass® module

Insert an HDMI® cable into an HDMI jack on the rear of the television

Insert the other end of the HDMI® cable into the HDMI OUT Video to TV jack on the control console

Connect the power cable to the AC Power jack on the Acoustimass® module and to a power outlet

Connect the cable attached to the power supply to the Power jack on the control console

Connect one end of the 3-pin plug to the power supply and the other end to a power outlet

Note: The use of an "HDMI-to-DVI" cable is acceptable for monitors that do not have an HDMI® input. Use of "HDMI-to-DVI" adapters or switches is not supported.

For speaker placement suggestions, see Speaker placement.

Was this helpful?

Submit

Thank you for submitting your comments.