Back to article
3348
Using component video cables with your system
You can connect video to your system and/or pass it along to your TV using a component video adapter. This provides the best image quality from your system.
To set up the component video adapter:
Before you begin
Be sure you have the correct adapter. The component video adapter for your system is identified by a black Composite connector on the two-plug side of the adapter.Connecting the adapter
- Connect the two-plug side of the adapter to the S-Video and Composite jacks in the VIdeo OUT section on the back of the system console
- Connect a component video cable to the other end of the adapter. Be sure to match the red, green and blue colored plugs on the cable to the same colored connectors on the adapter
- Connect the other end of the component cable to the red, green and blue component video jacks on your TV
Configuring your system
- Power on your system
- On the remote control, press the Settings button (Tip: If the system menu does not appear on your TV, be sure the correct TV input is selected)
- Scroll down to System Setup, then press the Enter button
- Scroll down to Video Output
- Scroll right to select YPbPr
- Press the Exit button to exit the menu
Was this article helpful?
Thank you for your feedback!