Back to article
3348
Programming radio station presets
Your system can store radio station presets so you can quickly switch to stations you frequently listen to at the press of a button. Find out how to save presets to your system.
Store radio station presets by following these steps:
- Using the remote, tune to the desired station
- Lift up the media center door
- Press Store on the media center control panel. The display shows "STORE TO PRESET <number>" indicating the lowest available preset number. If you do not want to save the station to this preset number, press the Channel/Chapter/Preset/Track buttons to select a new number.
- Press Store again to save the preset. The display shows, "STATION SAVED to <number>"
- If you attempt to store more than 25 AM or 25 FM stations, the media center will display the message "ALL PRESETS FULL … … ERASE A PRESET"
- To change an existing preset, you must erase the preset station and then store a new station to that preset number.
To erase a radio station preset:
- On the remote control, select the preset you want to erase.
- On the system console, press the Erase button: ERASE PRESET? appears on the system display
- Press the Erase button again to erase the preset: PRESET ERASED appears on the display.
Was this article helpful?
Thank you for your feedback!