Back to article
3348
Putting a system into Setup mode
Entering Setup mode lets you connect a device to the Wi-Fi network broadcast by the Bose system. This is useful for system set up and diagnostics.
Enter Setup mode.
If a Bose app or instructions ask you to put your system in Setup mode:
- Press and hold the Control button on the back of the pedestal for about 3 seconds
- Wait until the Wi-Fi light glows solid amber and the system display shows SETUP SEE INSTRUCTIONS, then relase the button
Tip: Holding the button for 10 seconds will reboot the pedestal. So, if the light does not glow amber within a few seconds, release it and try again - For next steps, refer to the Bose app or instructions that asked you to enter Setup mode.
Was this article helpful?
Thank you for your feedback!